Avant Vanta 2 Nano Toothpick FPV Racing Drone


Out of stock

Add to compare



1x Vanta 2 Nano frame kit (Baseplate”3mm thick” cut in 45deg)
1x SI F4 FC / ESC 2-4s 16 x 16mm / 25-200mw VTX with IRC Tramp setup (Flywoo F411 target)
4x Avant 1103-7650kv motor (Brotherhobby Rebranded)
1x Runcam Nano 2 (2.1mm)
1x 3d printed TPU VTX antenna mount
2x 3d printed TPU camera mount
1x Rubycon 16V 100uF capacitor
2x Avant lipo strap
1x Non-slip lipo pad
1x Gemfan 2023 Tri-Bladed prop (4CCW / 4CW)


Lipo should be mounted slightly to the front for proper CG
Insert the prop all the way down to the top of the motor bell
Set higher camera tilt angle by moving the TPU camera mount upward and downward (Up to 50deg)
Insert the props in the proper direction as shown in the diagram below (No prop screw is needed)
2S-3S setup (450-650mah up to 5.5mins flight time)
AC900 Rx comes preset for Frsky protocol (Same binding procedure as XM+)
Use below PID settings for 2s setup