Holybro Kakute F7 HDV Flight Controller Tekko32 F3 HDV 40A 3-6S Blheli_32 4 In 1 Brushless ESC


Out of stock

Add to compare



Kakute F7 HDV Flight ControllerMCU: STM32F745 32-bit processorIMU:PMU6000Barometer: BMP280USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)6 hardware UARTS (UART1,2,3,4,6,7)All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvert hack”.Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.TF card for Blackbox loggingDimensions: 35x35mmMounting Holes: Standard 30.5mm square to center of holesWeight: 8g
Tekko32 F3 HDV 40A ESC32bit ESC with BLHELI32 firmwareSupports 3-6S lipo inputPWM input, TLM supportedVoltage output (VBAT)NO BECSupports oneshot / Multishot / Dshot PWMMounting holes 30.5×30.5mmSupports damped lightF3 MCU, runs double faster than F051Extra Cap needed for high current or 6s usageDimensions: 44x37x6mmWeight: 11.6g

• Supports Betaflight, Butterflight, and Cleanflight.• High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer. • Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external GPS/magnetometer units.• Dedicated bootloader button for easy firmware flashing.• Low-profile design fits into even very compact frames.• Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad only).• Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the KAKUTE F7 HDV monitors voltage directly from the power supply.• Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V output up to 1.5A to power peripherals such as receiver, FPV camera, or LED strip. 8V output up to 2A to DJI FPV VTx.• Supports BLHeli pass-through for easy ESC upgrade and configuration.

Package Included:
1 x Kakute F7 HDV Flight Controller 
1 x Tekko32 F3 HDV 40A Brushless ESC1 x Electrolytic capacito: 1000uF 35v1 x 8pin to 8pin 1mm pitch 65mm cable 1 x 8pin to 8pin 1mm pitch 25mm cable